Volkswagen Marine SDI Series Operating Manual page 50

1 3
1 2
Before reinstalling the impeller, grease it
with silicone spray or glycerine.
Push the impeller onto the shaft and
press the rubber protection cap into the
impeller.
Screw on the cover again with the
screws 3. Always use a new sealing ring
when mounting the cover.
INSPECTION
5
1 1
BM4-014M
Insert the seawater pump in the bracket
and secure it with the screws 5 on the
bracket.
Press in the retaining clip 2 - left-hand
illustration - again and push the two coolant
hoses onto the seawater pump. The rear
hose must engage. Tighten the clip 1 of the
front hose again.
Tension the tensioner 4 with a suitable
spanner and lay the ribbed V-belt on the
rollers in the running direction.
Important
Slowly guide back the tensioner
with the spanner - danger of
injury!
Open the seawater valve.
Start the engine and check the cooling
system for leaks.
INSPECTION
4
BM4-015M
49
49