Volkswagen Marine SDI Series Operating Manual page 13

OPERATION
2 - Multi-function
(MFI)
The following faults may be indicated in the
left-hand area of the MFI:
Coolant level
If a fault occurs in the closed cooling system
while driving, this is indicated by a flashing
symbol in the left-hand area of the multi-
function indicator.
In this case, switch off the engine
immediately and check whether ...
-
sufficient coolant is present.
-
the coolant system is leaky.
Important
Exercise
opening the coolant cap! When
the engine is hot, the cooling
system is pressurised - danger of
scalding! Therefore, allow the
engine to cool down before
unscrewing the cap.
Exercise
when working in the engine
compartment!
Refer to the safety instructions
provided on Page
before carrying out any work on
the engine or in the engine
compartment.
If the fault cannot be eliminated, consult the
nearest VW Marine Service Partner.
12
12
indicator
caution when
particular caution
17 onwards
Water separator
This symbol appears when water has col-
lected in the fuel filter on the engine.
In this case, switch off the engine and drain
the water from the fuel filter
- see page 40.
Attention
Refer to the safety instructions
provided on Page 17 onwards
before carrying out any work on
the engine or in the engine
compartment.
3 - Alternator
This warning lamp lights up when you
switch on the ignition. It should go out again
once the engine is running.
If the alternator warning lamp lights
up during operation:
-
Switch off the engine immediately and
check the ribbed V-belt.
If the ribbed V-belt is OK, the fault is prob-
ably in the alternator or the regulating
switch. If the damage cannot be repaired,
please contact the nearest VW Marine Ser-
vice Partner.
Note
The engine may not:
-
be operated with the battery dis-
connected, as otherwise the alter-
nator will be damaged.
-
operated without the alternator
ribbed V-belt, as otherwise the
front vibration damper will be
damaged.
OPERATION