Removing The Keyboard/Ccd; Remove The Keyboard - Clevo W270BUQ Series Service Manual

Disassembly
Removing the Keyboard
Figure 8
Keyboard Removal
1. Turn off the computer, and remove the battery
a. Remove screws from the
2. Remove screws
bottom of the computer.
to unsnap the LED cover module (use the eject pin tool provided to do this
b. Turn the computer over, 7
unsnap up the LED cov-
3. Turn the computer over, unsnap up the LED cover module
er module from the cent-
4. Remove screws
er of the computer.
5. Carefully lift the keyboard
c. Remove screws from
board ribbon cable
the keyboard.
pins
d. Carefully lift the key-
6. Carefully lift up the keyboard
board up and disconnect
the keyboard ribbon ca-
ble from the locking col-
a.
lar socket by using a flat-
head screwdriver to pry
the locking collar pins
away from the base.
e. Remove the keyboard.
b.
c.

8. LED Cover Module
14. Keyboard
11 Screws
2 - 12 Removing the Keyboard
-
from the bottom of the computer (inside the battery compartment), and then press at point
1 6
- from the keyboard
9 13
up, being careful not to bend the keyboard ribbon cable
14
from the locking collar socket
15
away from the base (Figure 8d).
17
(Figure
14
7
1
2
6 5 4
8
9
10 11 12 13
(page 2 - 5) and the component bay cover
from the center of the computer
8
(Figure 8c).
by using a flat-head screwdriver to pry the locking collar
16
8e) off the computer.
d.
3
e.
14
Keyboard Tabs
(page 2 - 9).
Figure 8a).
(Figure 8b).
. Disconnect the key-
15
14
15
17 17
16

Re-Inserting the
Keyboard
When re-inserting the
keyboard firstly align the
four keyboard tabs at
the bottom (Figure 8e)
at the bottom of the key-
board with the slots in
the case.