Table of Contents
Advertisement
Removing the Keyboard/CCD
1. Turn off the computer, and remove the battery
-
2. Remove screws
from the bottom of the computer (inside the battery compartment), and then press at point
1
6
to unsnap the LED cover module (use the eject pin tool provided to do this
7
3. Turn the computer over, unsnap up the LED cover module
4. Remove screws
-
from the keyboard
9
13
5. Carefully lift the keyboard
14
board ribbon cable
from the locking collar socket
15
pins
away from the base
(Figure
17
6. Carefully lift up the keyboard
a.
1
2
6
5
b.
8
c.
9
10
11
12
(page 2 -
5) and the component bay cover
from the center of the computer
8
(Figure
11c).
up, being careful not to bend the keyboard ribbon cable
by using a flat-head screwdriver to pry the locking collar
16
11d).
(Figure
11e) off the computer.
14
d.
7
4
3
e.
13
Keyboard Tabs
(page 2 -
Figure
11a).
(Figure
. Disconnect the key-
15
14
15
17
17
16
Re-Inserting the
Keyboard
When re-inserting the
keyboard firstly align the
14
four keyboard tabs at
the bottom
(Figure
at the bottom of the key-
board with the slots in
the case.
Removing the Keyboard/CCD 2 - 15
Disassembly
Figure 11
Keyboard / CCD
9).
Removal
a. Remove screws from the
bottom of the computer.
11b).
b. Turn the computer over,
unsnap up the LED cov-
er module from the cent-
er of the computer.
c. Remove screws
the keyboard.
d. Carefully lift the key-
board up and disconnect
the keyboard ribbon ca-
ble from the locking col-
lar socket by using a flat-
head screwdriver to pry
the locking collar pins
away from the base.
e. Remove the keyboard.
11e)
8. LED Cover Module
14. Keyboard
11 Screws
from
Advertisement
Table of Contents
