Troubleshooting Tips - Beko BEPN 09C User Manual

10

Troubleshooting tips

Troubles
1. Unit does not start when
pressing on/off button
2. Not cool enough
3. Noisy or vibration
4. Gurgling sound
5. Power shut off at
Heating mode
Mobile type air conditioners (local air conditioners) / User Manual
Possible causes
- P1 appears in the display
window
- Room temperature is lower
than the set temperature.
(Cooling mode)
- The windows or doors in the
room are not closed.
- There are heat sources inside
the room.
- Exhaust air duct is not
connected or blocked.
- Temperature setting is too
high.
- Air filter is blocked by dust.
- The ground is not level or not
flat enough.
- The sound comes from the
flowing of the refrigerant
inside the air-conditioner.
- The automatic over heat
protection function. When
the temperature at the air
outlet exceed 70°C/158°F,
the device will stop.
Suggest remedies
Drain the water in the bottom
tray.
Reset the temperature.
Make sure all the windows and
doors are closed.
Remove the heat sources if
possible.
Connect the duct and make
sure it can function properly.
Decrease the set temperature.
Clean the air filter.
Place the unit on a flat, level
ground if possible.
It is normal.
Switch on again after the unit
has cool down.
25 / 28 EN