Installation Instructions; Exhaust Hose Installation - Beko BEPN 09C User Manual

8

Installation instructions

Exhaust hose Exhaust hose assembly
Unit adaptor Window slider adaptor
Type window installation
Fig. 16a
Exhaust hose
Exhaust hose assembly
Wall exhaust adaptor A
Unit adaptor
Type wall window installation
Fig. 16b
Hook
Hole Seat
Adaptor Lower groove
Fig. 17
Expansion plug
position
Adaptor A
Adaptor
cap
Fig. 18
Fig. 19
20 / 28 EN

8.1 Exhaust hose installation

The exhaust hose and adaptor must be installed or removed in
accordance with the usage mode.
COOL, HEAT (heat pump type) or AUTO
mode
FAN, DEHUMIDIIFY or HEAT (electrical
heat type) mode
1. Install the adaptor B and adaptor I onto the exhaust hose as
shown in Fig. 16a or Fig. 16b. Refer to the previous pages for
window kit installation.
2. Resert the hook of the Exhaust hose into the hole seat of
the air outlet and slide down the Exhaust hose along the
arrow direction (See Fig. 17) for installation.
Make sure the The exhaust hose can be installed into the wall
adaptor is inserted
into the lower
(Not applicable to the units without adaptor A, expansion plugs
groove of the air
outlet.
and wooden screws of Accessories).
1. Prepare a hole in the wall. Install the wall Exhaust adaptor
A onto the wall (outside) by using 4 expansion plugs and
wooden screws, be sure to fix thoroughly. (See Fig. 18)
2. Attach the Exhaust hose to wall Exhaust adaptor A.
C
max 120CM
min 30CM
Important:
Do not over bend the exhaust hose (See Fig. 19)
A
Mobile type air conditioners (local air conditioners) / User Manual
Note: Cover the hole using the adaptor
cap when not in use.
• The exhaust hose can be compressed or
extended moderately according to the
installation requirement, but it is desirable to
keep the hose length to a minimum.
Warning:
Make sure that there is no obstacle
around the air outlet of the exhaust
hose (in the range of 500mm) in order
to the exhaust system works properly.
Install
Remove