Fitting Thermal Insulation To The Back Panel - Buderus Logalux LTN Series Installation Instructions For Contractors

5 Fitting
5.4.1

Fitting thermal insulation to the back panel

The thermal insulation is shown fitted to a single cylinder.
▶ Remove the fabric plugs from the hole devices in the back panel.
Fig. 11 Removing the fabric plugs from the hole devices
▶ Lay the thermal insulation sections for the back panel onto the back
panel.
Fig. 12 Fitting the thermal insulation sections for the back panel
▶ Lay the bottom/back thermal insulation section ( Fig. 10, [1],
page 13) under the cylinder and insert the slits into the cylinder feet.
Fig. 13 Laying the thermal insulation section under the cylinder
14
▶ Push the top/back thermal insulation section ( Fig. 10, [2],
page 13) against the bottom section, so that the bottom hook locking
bracket latches into place.
Fig. 14 Push the top thermal insulation section against the bottom
thermal insulation section
▶ If required, attach the assembly aids.
6 720 817 906-18.1T
Fig. 15 Attaching the assembly aids
▶ Wind the joined thermal insulation sections around the cylinder.
6 720 817 906-16.1T
Fig. 16 Winding the thermal insulation around the cylinder
6 720 817 906-07.1T
Logalux LTN/LTD/LTH/LF 400...3000 – 6 720 818 806 (2015/12)
6 720 817 906-19.1T
6 720 817 906-21.1T
6 720 817 906-20.1T