Starter Motor Removal/Disassembly; Armature Inspection; Starter Motor Re-Assembly/Installation - Sym JET 4 R 50 Series Service Manual

16. ELECTRICAL EQUIPMENT

Starter Motor Removal/Disassembly

Remove body cover.
Remove bolt and oil pump control cable.
Disconnect starter motor harness coupler.
Remove 2 bolts for separation starter motor
and gasket.
Remove 2 bolts for disassembly the starter
motor.

Armature Inspection

Check the armature for discoloration or other
damage. It may be short-circuiting if dark
surface on the shifter found.
Caution
Do not clean the shifter surface with
sandpaper.
Check continuity 1) both the shifter surface and
shaft, 2) among the shifter surfaces. It can be
in continuity among the shifter surfaces, but
both the shifter surface and the shaft cannot be
in continuity.

Starter Motor Re-Assembly/Installation

Re-assemble and install the starter motor in
reverse order of removal procedures.
16-16
Starter motor
Motor housing
Carbon bracket
SYM
2 bolts
Armature
Spring
O-ring