Install And Connect The Router; Unpack The Router; Rack Mount The Chassis - Cisco 1100 Series Hardware Installation Manual

Install and Connect the Router

This chapter describes how to install and connect Cisco 1100 Terminal Gateway Routers to LAN and WAN
networks.
Warning
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Warning Only skilled person should be allowed to install, replace, or service this equipment. Refer to statement 1089
for description of skilled person. Statement 1090
Installing the Cisco 1100 Series Terminal Gateway Routers involve these tasks:
•
•
•
•
•
•

Unpack the Router

Unpack the router only when you are ready to install it. If the installation site is not ready, to prevent accidental
damage, keep the chassis in its shipping container until you are ready to install.
The router, accessory kit, publications, and any optional equipment you order may be shipped in more than
one container. When you unpack the containers, check the packing list to ensure that you have received all
listed items.

Rack Mount the Chassis

The Cisco 1100 Terminal Gateway Router can be installed in 19-inch (48.26-cm) or 23-inch (58.42-cm) racks.
Use the standard brackets shipped with the router for mounting the chassis.
Unpack the Router, on page 19
Rack Mount the Chassis, on page 19
Chassis Grounding, on page 23
Connect Power Cable, on page 25
Connect WAN and LAN Interfaces, on page 33
Configure the Router at Startup, on page 35
C H A P T E R
Hardware Installation Guide for the Cisco 1100 Terminal Gateway
3
19