Ethernet Connection; Required Tools And Equipment For Installation And Maintenance - Cisco 1100 Series Hardware Installation Manual

Prepare for Router Installation
See the following online document for more information about network connections and interfaces:
• Cisco Modular Access Router CableSpecifications

Ethernet Connection

Note
To reduce the risk of electric shock, the following ports must be connected through an approved network
termination unit with integral circuit protection if the port cabling is routed outdoors: ethernet. Statement 1044
The IEEE has established Ethernet as standard IEEE 802.3. The routers support the following Ethernet
implementations:
• 1000BASE-T—1000Mb/s full-duplex transmission over a Category 5 or better unshielded twisted-pair
• 100BASE-T—100 Mb/s full-duplex transmission over a Category 5 or better unshieldedtwisted-pair
• 10BASE-T—10Mb/s full-duplex transmission over a Category 5 or better unshielded twisted-pair (UTP)
See the Cisco Modular Access Router Cable Specifications document at Cisco.com for information about
Ethernet cables, connectors, and pinouts

Required Tools and Equipment for Installation and Maintenance

You need the following tools and equipment to install and upgrade the router and its components:
• ESD-preventive cord and wriststrap
• Number 2 Phillipsscrewdriver
• Phillips screwdrivers: small, 3/16-in. (4 to 5 mm) and medium, 1/4-in. (6 to 7mm)
• To install or removemodules
• Screws that fit yourrack
• Wire crimper
• Wire for connecting the chassis to an earthground:
(UTP) cable. Supports the Ethernet maximum length of 328 feet (100 meters).
(UTP) cable. Supports the Ethernet maximum length of 328 feet (100 meters).
cable. Supports the Ethernet maximum length of 328 feet (100 meters).
• 6 AWG
Hardware Installation Guide for the Cisco 1100 Terminal Gateway
Ethernet Connection
17