Replacing The Radio Gateway - Siemens FXS2061-O User Manual

4.5 Replacing the radio gateway

Building Technologies
Fire System
When the radio gateway is replaced, the saved radio gateway data can be
transferred to the new radio gateway.
The new radio gateway takes over the identity of the old radio gateway.
The old radio gateway must no longer be used in the same fire detection
installation, as the old radio gateway uses the same net ID as the new radio
gateway.
After it has been reset to the factory settings, the old radio gateway can be used
again.
The factory settings must be reset outside of the range of the radio network in
which the old radio gateway was incorporated.
The new radio gateway with a new, connected battery pack is available.
The old radio gateway is logged onto a fire control panel.
The MCL-USB adapter (radio) FDUZ227 is connected to the old radio gateway
using a cable.
Follow the instructions in the documentation for your fire control panel.
1. Switch the detector line off.
2. Remove the cable connection to the detector line on the radio gateway.
3. Using the 'FXS2061-O Wireless Diagnostic Tool' software, select the relevant
radio gateway in the main menu
4. Select the 'Update' command from the 'Exchange Gateway' menu bar.
5. Enter your password. The initial password is '1234'.
6. Follow the instructions as they are shown in the window.
7. Once you have completed all of the steps, click on 'OK'.
The data is loaded from the old gateway.
The window with the command for changing the gateway appears.
Replacing the radio gateway
'Network'.
Operation
4
55 | 64
A6V10425605_b_en_--
2016-12-12