Siemens FXS2061-O User Manual page 22

GUI
3
Menu bar
Main menu
Submenu
Check
Diagnostic
or <CTR+2> and <1>
Check + alarm
or <CTR+2> and <2>
Check + test alarm
or <CTR+2> and <3>
Alarm
or <CTR+2> and <4>
Test alarm
or <CTR+2> and <5>
Read status
or <CTR+2> and <8>
Simulate fault
or <CTR+2> and <9>
Warning DL2
or <CTR+2> and <0>
Set DL1
Device information
or <CTR+3> and <1>
Parameter
or <CTR+3> and <2>
Position
or <CTR+3> and <9>
Device Discover devices ...
Discover devices of same
network ...
Get all data
Get connectivity state
Get neighbourhood table
Get battery level
Get total running time
Remove from radio cell
Update Periphery Update Wizard
Exchange Gateway
22 | 64
Building Technologies
Fire System
Action
The device test is triggered.
The device and alarm tests are triggered.
1
The device and test alarm tests are triggered.
The device alarm is triggered.
1
The device test alarm is triggered.
The status of the device is read.
A device fault is simulated.
1
Danger level 2 is activated. See also 'Setting the danger level
1
Danger level 1 is set.
The current information of the selected device is displayed.
The current parameters of the selected device are displayed.
Set the danger level for inputs.
1
Searches for devices in range and displays their identification
data.
Recognizes devices in the same network.
Displays the connection status to the neighboring devices.
Displays the current connection data for the neighboring
devices.
Displays the battery charge state in 5 levels.
The total running time is read.
Displays the connection status to the neighboring devices.
Displays the current connection data for the neighboring
devices.
Displays the battery charge state in 5 levels.
The total running time is read.
The device is removed from the radio cell.
Starts a wizard for the connected peripheral devices detection
and update
Replace a radio gateway
38]'.
A6V10425605_b_en_--
2016-12-12