Notes On Operation - Westfalia 85 33 70 Instruction Manual

7. After you have finished cutting withdraw the cutting shaft from the
work piece before turning off the power drill.

Notes on Operation

 An initial bore is required for cut-outs.
 When cutting for a longer period of time or when processing
harder workpieces, apply cutting oil to the cutting shafts to cool
and to protect the cutting shaft.
 Always hold the cutting shaft vertically against the workpiece.
 Do not use force when pushing the cutting shaft against the
workpiece. If you are not satisfied with the result, check the cut-
ting shaft for wear.
 Lead the tool to the workpiece only when it is switched on.
 Do not tilt the tool to the side.
 Work with a lower feed rate when cutting curves to prevent
jamming of the driving engine (danger of kickback).
 Do not use the impact drill function when operating the sheet
metal nibbler attachment.
Operation
18