Sparkfun Electronics Simon SMD Information & Instructions page 6

CONTINUE WITH THE BOTTOM OF THE BOARD
Now that you've successfully soldered down your
first SMD component, use the same method to
place and solder the following components.
10uF Capacitor
towards the rounded end on the PCB's silkscreen.
10
10uF Capacitor
22uH Inductor
white outline after you've soldered both legs.
11
22uH Inductor
MBRA140 Diode
line on the diode matches the line on the PCB's silkscreen. The
white line is similar to the line on the 10uF capacitor in step 10.
12
MBRA140 Diode
Page 10
[ STEPS 10 T0 16 ]
The white end of the capacitor should point
Make sure the inductor remains inside it's
Before soldering, double-check that the white
Remember, components highlighted yellow are polarized.
BOTTOM OF BOARD
Page 11