Sparkfun Electronics Simon SMD Information & Instructions page 10

For step 21, use the same 3-step process you learned earlier (Step 8,
Page 8). A common error for these smaller types of components is a
jumper. To help avoid these, try not to use too much solder.
21
Reheat Start-Pad
I
Slide Into Place
II
Remove Iron
III
Page 18
Understand the alignment of the component is important, and should
be oriented to look like the picture.
Add solder to the remaining 4 pads.
IV
BAD
Learn how to fix a jumper on Page 40 in the Troubleshooting section.
GOOD
Page 19