Troubleshooting Jumpers - Sparkfun Electronics Simon SMD Information & Instructions

TROUBLESHOOTING JUMPERS

As you solder the other pins down, if you solder multiple pins together,
I
don't worry about it! It can be easily fixed. There are actually two pins
under that blob.
II
Locate a piece of solder wick.
Page 40
Put a small amount of solder on the end of your iron (this will transfer
III
heat from iron to wick to the jumper). Sandwich the wick in between the
iron and the solder jumper.
IV
Hold still for 2-3 seconds. You will see solder start to flow up the wick.
V
Pull both away. Nice and clean!
Page 41