DeWalt D28715 Original Instructions Manual page 29

12. Extension cables.
Before use, inspect the extension cable and
replace if damaged. When using the tool
outdoors, only use extension cables intended
for outdoor use and marked accordingly.
13. Use appropriate tool.
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which
it was intended. Do not force the tool.
WARNING! The use of any accessory
or attachment or performance of any
operation with this tool other than those
recommended in this instruction manual
may present a risk of personal injury.
14. Check for damaged parts.
Before use, carefully check the tool and mains
cable for damage. Check for misalignment and
seizure of moving parts, breakage of parts,
damage to guards and switches and any other
conditions that may affect its operation. Ensure
that the tool will operate properly and perform
its intended function. Do not use the tool if any
part is damaged or defective. Do not use the
tool if the switch does not turn it on and off.
Have any damaged or defective parts replaced
by an authorised D WALT repair agent. Never
E
attempt any repairs yourself.
15. Unplug tool.
Switch off and wait for the tool to come to a
complete standstill before leaving it unattended.
Unplug the tool when not in use, before
changing any parts of the tools, accessories or
attachments and before servicing.
16. Avoid unintentional starting.
Do not carry the tool with a finger on the switch.
Be sure that the tool is switched off before
plugging in.
17. Do not abuse cord.
Never carry the tool by its cord. Never pull the
cord to disconnect from the socket. Keep the
cord away from heat, oil and sharp edges.
18. Store idle tools.
When not in use, tools must be stored in a dry
place and locked up securely, out of reach of
children.
19. Maintain tools with care.
Keep the tools in good condition and clean
for better and safer performance. Follow the
instructions for maintenance and changing
accessories. Keep all handles and switches dry,
clean and free from oil and grease.
20. Repairs.
This tool is in accordance with the relevant
safety regulations. Have your tool repaired by
an authorised D WALT repair agent. Repairs
E
should only be carried out by qualified persons
using original spare parts; otherwise this may
result in considerable danger to the user.
Additional Safety Instructions for
Chop Saws
• Always wear regular working gloves while
operating this tool.
• Keep hands away from the cutting disc. Never
cut workpieces that require manual action
closer than 15 cm from the rotating cutting disc.
• Do not cut workpieces less than 1.2 mm in
thickness when using the cutting disc supplied
with this tool.
• Do not operate this tool without guards in place.
• Do not perform any operation freehand. Use the
material clamp to clamp the workpiece securely.
• Never reach in the back of the cutting disc.
• Always position the tool on a flat, stable
surface that is well maintained and free of loose
materials, e.g., chips and cut-offs.
• Before using, inspect the cutting disc for cracks
or flaws. Discard the cutting disc if a crack or
flaw is evident.
• Make sure the cutting disc is not contacting the
workpiece before the tool is switched on.
• In operation, avoid bouncing the cutting disc or
giving it rough treatment. If this occurs, stop the
tool and inspect the cutting disc.
• Do not operate the tool while standing in line
with the cutting disc. Keep other persons away
from the work area.
• Be aware of cutting chips and the material
being cut. They may be sharp and hot. Allow
cut off parts to cool before handling.
• The spark deflector becomes hot during use.
Avoid touching or adjusting the spark deflect or
immediately after operation.
• Switch off the tool and wait for the cutting
disc to stop before moving the workpiece or
changing the settings.
• After switching off, never attempt to stop the
cutting disc by pressing against the side of
the disc.
EN GL IS H
27