INLET - OUTLET PLUMBING OPTIONS
Always install either a single bypass valve (provided)
or, if desired, parts for a 3 valve bypass system (not
included) can be purchased and assembled, as shown
in Figure 6. Bypass valves allow you to turn off water
to the Central Water Filtration System for maintenance
if needed, but still have water in house pipes.
Use either:
Copper pipe
Threaded pipe
PEX (Crosslinked Polyethylene) pipe
CPVC plastic pipe
Other pipe approved for use with potable water
IMPORTANT: Do not solder with plumbing attached to
installation adapters and single valve
bypass. Soldering heat will damage the
adapters and valve.
CROSS OVER
In what direction does the water flow?
Be sure to plan piping so water flow is to the
Central Water Filtration System valve INLET.
Plan a crossover if flow is from left to right.
Treated
Water from
Valve
OUTLET
To Central Water
Filtration System
Plan the Installation
Untreated
Water to
Valve
INLET
FIG. 5
3 VALVE BYPASS
Central Water Filtration
OUTLET
System
CONNECTING PLUMBING TO VALVE
OUT
Use teflon tape,
pipe joint com-
pound or both
Use teflon tape,
pipe joint com-
pound or both
9
Central Water Filtration
INLET
System
IN
1" NPT Sweat
Adapter (2)
(not included)
1" NPT
2 of each
Adapter
included
Clip
Bypass
Valve
Valve
Inlet
OUT
IN
1" NPT Sweat
Adapter (2)
(not included)
Clip
1" NPT
Adapter
2 of each
Valve
included
Inlet
FIG. 6
FIG. 7