Progress PG1803 User Manual page 27

Problem
There is too much frost and
ice.
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis-
play.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
The door is not closed cor-
rectly.
The FastFreeze function is
switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The FastFreeze or Shop-
ping function is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula-
tion in the appliance.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
Progress 27
Solution
Refer to "Closing the door".
Refer to "FastFreeze function".
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or Shop-
ping manually, or wait until the
function resets automatically to
set the temperature. Refer to
"FastFreeze or Shopping func-
tion".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and display
shuts off for a short time.
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Open the door only if necessa-
ry.
Refer to "FastFreeze function".
Make sure that there is cold air
circulation in the appliance.