Table of Contents
Advertisement
indicated by the icon
.
•
Use of automatic Data Logger
•
In measure mode press
•
When the automatic data saving is running, the icon
•
When it is set, but not in operation, the icon on the screen remains fixed. When the 1000 total
values are reached, the recording stops automatically.
Note: Scrolling through the parameters, the recording stops.
P8.2 Memory emptying
Access this menu and select YES to clear the saved data and empty the memory.
Next to the M+ icon. It shown the total number of data stored.
• Example of automatic Data Logger mode
Example: automatic pH recording on internal memory every 2 minutes
Access the LOG SETTING P8.0 setup menu.
•
Enter the LOG TYPE P8.1 menu, press
•
Use the directional keys to change the number that flashes on the display. Enter "2" and confirm with
•
.
Go back to measure mode.
The icon
•
Data Logger has been set. Press
that the storage is in progress. The number next to the M+ icon indicates how much data has been
saved for that parameter.
Press again
•
Note: automatic recording is suspended when the measurement parameter is changed.
• Example of manual Data Logger mode
Example: recording a Conductivity value in manual mode
•
Access the LOG SETTING P8.0 setup menu.
Enter the LOG TYPE P8.1 menu, press key
•
•
Confirm with
Press
to save the value. The number next to the M+ icon indicates how much data has been saved
for that parameter.
Note: Manual or automatic saving of a value is confirmed by a sequence of flashes of the green LED
, change the value of the acquisition time. Confirm the setting with the key
to start and end automatic recording.
is lit in the lower string of the display, which indicates that an automatic frequency
to end the recording.
and return to measure mode, go to the COND screen
flashes on the display.
and move with directional keys to MINUTES.
to start recording; the icon
and move with the directional keys to MANUAL.
24
starts flashing, indicating
.
Advertisement
Table of Contents
