Start-Up; Connection Of The Power Supply; Power On, Date And Time Update, Power Off - XS Vio OXY 70 Instruction Manual

• Start-up

• The device leaves the factory ready to be used by the user.
Batteries are included.
•

• Connection of the power supply

• in addition to batteries, the instrument can be powered through electricity grid;
check that the electrical standards of the line on which the instrumentation is to be installed
•
comply with the voltage and operating frequency of the instrument;
• use the original power supply only;
connect the power supply to the USB cable and the other end of the cable (Micro USB) to the
•
Micro USB port located on the front of the instrument;
Connect the power supply to an electric socket easy to reach.
•
ATTENTION
Danger of death or serious injury from electric shock.
Contact with live components can lead to injury or death.
Use the adapter supplied only.
•
Do not put the power supply in contact with liquids nor in a condensing environment. Avoid
•
thermal shock.
All electrical cables and connections must be kept away from moisture or liquids.
•
Check that the cables and plugs are not damaged, otherwise replace them.
•
During use, do not cover the power supply and/or do not place it inside containers.
•
The electricity supply can be originated from the power grid and from the USB port of a PC too.
If the instrument is powered by PC, the icon indicating the battery status disappears from the display
Opening the DataLink+ software, on the display it is shown this icon

• Power on, date and time update, power off

Turn on the system by pressing the button
appears:
• model and firmware of the instrument;
• settings relating to the most important parameters and possible information about the DHS sensor;
On first use, and after each battery replacement, the instrument during the start-up phase will request the
updating of the date and time.
• Using the directional keys, update the year and confirm with the key
operation with the month and day, and subsequently with hours and minutes.
• The instrument will enter measure mode in the last parameter used.
To switch off the instrument, press the key
. The display initially activates all segments and then
in measure mode.
11
.
. Carry out the same
.