IBM 5294 Setup Procedure page 47

After you press the Enter key, the code that you entered in the previous section
of this manual appears in field 1->. The code you just entered should appear
beside the 0 on your display.
Press the Enter
~
key.
Does the two-digit code that you just entered appear beside
the correct 0 on your display?
YES
- -
-
-
-
T
Press the Enter key again to
store the information. Repeat
steps 3.34 through 3.40 for
each keyboard code on the
IBM 5294 Setup Form.
When all codes are entered,
continue to Chapter 4.
NO
-
- -
- -
T
If the two-digit code does not
appear, press the Reset key and
repeat steps 3.34 through 3.40.
If the code still does not appear,
contact the person who planned
the setup and report the problem.
If an error code appears in the lower left corner of your display, refer to the Cus-
tomer Setup Error Codes in Appendix B for an explanation and recovery proce-
dure.
38 Control Unit Setup Procedure