IBM 5294 Setup Procedure page 11

Safety Precaution
The power cord and plug (when supplied) on your controller has been approved
for use with this controller and meets the necessary testing laboratory/test
house standards. For your safety, the power cord and plug must be connected
to a properly wired and groIJnded outlet. An improperly wired outlet or plug can
place hazardous voltages on accessible metal parts of this controller. The cus-
tomer is responsible for the outlet and the plug wiring.
If it becomes necessary to change the power cord or plug or if the outlet is
improperly wired, have the change made according to local or national code. A
new power cord may be ordered from your IBM sales representative.
The term work station refers to a display station or a printer.
D
Are properly wired and grounded electrical outlets installed?
D
Is the end of each work station cable that will attach to
the 5294 Control Unit labeled?
D
Are all the work stations (display stations and printers)
that will attach to the 5294 Control Unit set up and cabled?
YES NO
- -
-
-
-
-
-
-
-
-
...
a
Chapter 2
2 Control Unit Setup Procedure