IBM 5294 Setup Procedure page 17

I
Set the 5294 Power switch to On.
' i mmmmm
L8
,
All indicators go on for about 1 second; then, all indicators except
the Power indicator go off. After a few seconds, the Ready
indicator should come on.
Workstation
Active.
=
~
Normal
Are the Power and Ready indicators on?
YES
- -
-
-
-
~
NO
-
-
- - -
' Y
If the Power indicator is not on, make
sure the power cord is connected properly
at both ends. Also make sure there is
power to the outlet. If the indicator
is still not on, contact your service
representative.
If the Power indicator is on and the
Ready indicator is not on, contact your
service representative.
8 Control Unit Setup Procedure