Table of Contents
Advertisement
16
Control Unit Setup Procedure
•
You will need to use some specific keys to enter the information in the entry
fields of your display. The following gives the function of these keys in this
mode:
Cursor Right
EJ
and Cursor Left
EJ
keys:
The Cursor Right key moves the cursor one entry field or one character
to the right; the Cursor Left key moves the cursor one entry field or one
character to the left.
Roll", .
RolI+
~
.-
' G :)
Cursor UP...
and Cursor Down '+
keys:
The Cursor Up key increases the value of the entry field where the
cursor is located by one each time it is pressed. The Cursor Down key
decreases the value of the entry field where the cursor is located by one
each time it is pressed.
Enter key
The Enter key, when pressed TWICE, stores the information in the entry
fields.
Reset key (
II§) ):
The Reset key resets the display and/or terminates the customer setup
display. The Reset key must be pressed before any corrections can be
made if an error occurred during the setup display configuration.
These keys are in different positions on different keyboards.
The Cursor Up/and Cursor Down keys are typematic keys. When they are
held down, the value in the entry field where the cursor is located continues
to increase or decrease until the key is releaSed.
Advertisement
Table of Contents
