Table of Contents
Advertisement
Contents
10.2 Attach chains (10) to top tube anchor brackets (8) noting that anchor pins (6) are available in
different lengths.
10.3 Referring to
(16).
10.4 Fully back off four adjustable rollers on centre tube.
10.5 Insert top tube into lower end of centre tube, making sure that stop lugs on top tube will engage
with stops fitted in centre tube. Leave chains trailing out of lower end of centre tube.
10.6 Adjust rollers on centre tube
10.7 Referring to
through centre tube.
10.8 Referring to
and secure ram plate to centre tube with four screws (32).
10.9 Referring to
10.10 Referring to
cords lead correctly from the attachment lugs on the tube.
10.11 Referring to
bracket (34), cover (15) and lower pulleys (26-29).
10.12 Fully back off four adjustable rollers on bottom tube.
10.13 Referring to
and out through lower end of bottom tube. Ensure that cords pass between pulley and Spirol pin (21) on
each side of pulley.
10.14 Insert centre tube assembly into lower end of bottom tube, making sure that stop lugs on centre
tube will engage with stops fitted in bottom tube. Check that long cords lead correctly.
10.15 Adjust rollers on bottom tube
10.16 Referring to
10.17 Referring to
10.18 Referring to
links (37), making sure that rubber sleeve (36) is fitted on each chain.
10.19 Referring to
10.20 Referring to
screws (32).
10.21 Referring to
lower edge of pulley slot.
10.22 Referring to
friction assembly (19 - 23) and brake assembly (34 - 41).
Fig
6.3, assemble centre tube completely except for top track clamps (26) and cover
(Section
Fig
6.3, lead chains (15) up through centre tube, over sprockets (14) and down
Fig
6.7, feed free ends of chains through the holes in second stage ram plate (34)
Fig 6.2
secure four top track clamps (3) to top tube (1) with screws (2).
Fig 6.3
fit long cords (32) and short cords (34) to centre tube (31), ensuring that the
Fig 6.4
assemble bottom tube complete except for top track clamps (19), tube
Fig
6.4, lead long cords
(Section
Fig 6.3
fit top track clamps (26) to centre tube.
Fig 6.4
feed short cords out through slots for lower pulleys (26-29) in bottom tube.
Fig 6.7
fit chain adjusters (28 - 30) to first stage ram plate and connect chains using
Fig 6.3
feed free ends of long cords (32) through holes in ram plate.
Fig
6.7, temporarily secure first stage ram plate (31) to bottom tube (33) using two
Fig
6.4, fit lower pulleys (26-29), ensuring that short cords pass between pulley and
Fig
6.5, assemble fixed tube complete except for cord adjuster assemblies (27 - 31),
2).
(Fig 6.3
item 32) round top pulleys (11) inside bottom tube
4).
First
Previous
Next
Page
Page
Page
Previous
View
39
Advertisement
Table of Contents
