V.ORLANDI RP10 Installation, Operating And Maintenance Instructions page 65

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
7.1.2 FIFTH WHEEL WITH PIVOT BEARINGS
N
The following steps 1, 3 and 5 must also
O
be repeated on the fifth wheel's
T
E
opposite side.
Unscrew the two screws (3) and remove
1)
the pin (13);
Warning! Limb injury hazards!
2) Lift the fifth wheel plate (8) using appropriate lifting devices for 150 kg
weights;
Make sure that the fifth wheel plate (8) is
safely anchored and secure for extraction of
the meniscus (14). Dispose as specified in
section 9 DISPOSAL page 34/36;
3)
Position in the new meniscus (14);
4)
Remove the rubber bearing (16) and
the support bushing and replace them;
5)
Position in the fifth wheel plate
(8) being very careful to insert
the pedestals (15) into their
lodgings underneath the fifth
wheel plate (8);
6)
Insert the pin (13) and
block it with two screws
(3) and the relative safety
washers.
Torque wrench setting 25 Nm.
Each time the pivot bearings are replaced, all
N
the screws (3) and the safety washers must be
O
T
replaced as well. Dispose as specified in section 9
E
- DISPOSAL - page 34/36.
FIFTH WHEEL Rp10
14
3
13
3
13
8
16
PAG.
29/36
CHAP. 7
REV. 00
15