V.ORLANDI RP10 Installation, Operating And Maintenance Instructions page 59

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
If wear is found to be within limits given but inspection shows that there is
some clearance in the fifth wheel mechanisms and semi-trailer king pin,
proceed with clearance adjustments as specified in subsequent section 5
CLEARANCE ADJUSTMENTS at page 23/36.
N
The wear data is specified according to the ISO TS 20825
O
standard requirements.
T
E
Screwed onto the tractor unit carrier plate is comprised within the settings
provided at page 10/36 - section 2.1 INSTALLATION WITH CARRIER PLATE
or at page 11/36 - section 2.2 DIRECT INSTALLATION. For fifth wheels
provided with rubber bearings, check that the torque wrench setting of
the support-plate fixing screws (page 24 and page 28/36) is comprised
between 270 and 300 Nm. For fifth wheels provided with pivot bearings,
check that the torque wrench setting of the pivot fixing screws is at least
25 Nm.
Lubrication checksLubricate the fifth wheel plate (only for standard type fifth
wheels), the jaw lock mechanism and the king pin.
This chapter refers to the figures on pages 23-25/36.
Read the following instructions carefully before any operation:
N
The fifth wheel and the semi-trailer king pin are subject to wear,
O
that may vary subject to use and maintenance frequency.
T
E
FIFTH WHEEL Rp10
5 CLEARANCE ADJUSTMENTS
Wear safety shoes!
Wear safety gloves!
PAG.
23/36
CHAP. 5
REV. 00