Trouble Shooting - Beurer ANTELOPE.TECHWEAR User Manual

9. TROUBLE SHOOTING

Problem POSSIBLE CAUSE
Skin condition is dry
Unpleasant
feeling from
Stimulation
Stimulation intensity is
too high
Defect electrode
Skin Condition is dry
Stimulation is
weak / Cannot
feel Stimulation
Stimulation Intensity is
too low
Defect electrode
ANTELOPE - part of the Beurer group - BEURER GmbH
SOLUTION
• Spray the ANTELOPE.SPRAY directly on the electrodes.
• Drink enough water before, during and after training.
• If necessary, start your training with a light warm-up without stimulation.
DANGER
If stimulation cannot be felt at an intensity of 25%, SWITCH OFF the BOOSTER and
APPLY ANTELOPE. SPRAY directly to the electrodes in the textile. Then restart the ANTELOPE.APP
and make sure that all intensity levels are set to 0. Once this process is completed, restart using
your ANTELOPE.TECHWEAR according to the instructions in this manual. (see 8.1).
• Reduce stimulation intensity
• Stop stimulation
Please contact our Customer Care-Team.
Apply ANTELOPE.SPRAY directly onto the electrodes in the textile.
DANGER
If stimulation cannot be felt at an intensity of 25%, SWITCH OFF the BOOSTER and
APPLY ANTELOPE. SPRAY directly to the electrodes in the textile. Then restart the ANTELOPE.APP
and make sure that all intensity levels are set to 0. Once this process is completed, restart using
your ANTELOPE.TECHWEAR according to the instructions in this manual. (see 8.1).
Gradually increase stimulation intensity.
DANGER
If stimulation cannot be felt at an intensity of 25%, SWITCH OFF the BOOSTER and
APPLY ANTELOPE. SPRAY directly to the electrodes in the textile. Then restart the ANTELOPE.APP
and make sure that all intensity levels are set to 0. Once this process is completed, restart using
your ANTELOPE.TECHWEAR according to the instructions in this manual. (see 8.1).
Please contact our Customer Care-Team.
14