Antelope.2C-Booster; Putting On The Antelope.calf-Guards; Connecting The Antelope.calf-Guards And The Antelope.2C-Booster; Switching The Antelope.2C-Booster And Antelope.8C-Booster On/Off - Beurer ANTELOPE.TECHWEAR User Manual

NOTE
Be sure to observe which channel (I or II) the external cables are
connected to.

8.3 Putting on the ANTELOPE.CALF-GUARDS

1. Open the zipper on each CALF-GUARD.
2. Put on the CALF-GUARDS and make sure that the electrodes
lie flat on your skin without folds or wrinkles.
3. Close the zippers.
8.3.1 Connecting the ANTELOPE.CALF-GUARDS and the AN-
TELOPE.2C-BOOSTER
DANGER
DO NOT CONNECT THE
ANTELOPE.2C-BOOSTER IF THE BOOSTER IS TURNED ON.
1. Connect the magnetic button ending of the external cable
to the magnetic buttons on the textile. Only one cable pair
should be used to connect both CALF-GUARDS.
2. Connect the jack plugs of the external cables to the jack plug
input at the bottom of the 2C-BOOSTER.
NOTE
Be sure to observe which channel (I or II) the external cables are
connected to.
11
ANTELOPE.CALF-GUARDS WITH
8.4 Switching the ANTELOPE.2C-BOOSTER and ANTELOPE.8C-
BOOSTER ON/OFF
• On: Press and hold the [+]-button for three seconds.
• Off: Press and hold the [-]-button for three seconds.
ANTELOPE - part of the Beurer group - BEURER GmbH