Page 1
UTV DASH MOUNTED ROCKER SWITCH KIT MODEL NUMBER UTV-DRS-K 721 Sata Drive SAVE THESE INSTRUCTIONS Spring Valley, MN 55975 Important Safety Instructions USA /1-877-346-2050 are included in this manual. www.kfiproducts.com...
Note: Insert the switch carefully, if the hole is to small trim some of the plastic. This switch comes in two pieces for ease of installation, is not designed to come back apart after installing. UTV-DRS-K...
Page 4
GREEN Wire – to be conected to the small GREEN wire on the Winch’s Contactor or the lead that will run the winch direction -IN- if your contactor is wired differently than the KFI contactor. BlACK Wire – to be conected to the small BLACK wire on the Winch’s Contactor or the lead that will run the winch direction -OUT- if your contactor is wired differently than the KFI contactor.
Terminal #1 and #4 – Signal for Winch -IN- (Connect to small GREEN wire on contactor) Terminal #3 and #6 – Signal for Winch -OUT- (Connect to small BLACK wire on contactor) Terminal #7 and #9 – Ground (-) for LED (Connect to Frame ground or Battery (-) NEGATIVE post on the contactor) UTV-DRS-K...
This warranty does not cover repair Kappers Fabricating, Inc. (KFI) will warranty with when normal use has exhausted the life of a part a copy of your sales receipt from one of KFI’s retail or the equipment as a whole. locations as proof of purchase.
There is a clip on each side of the rocker switch. Push the top portion of the switch down and snap the clips into place. Shown in Figure 3. Figure 1 Plunger Note Bottom Clip Figure 2 Figure 3 UTV-DRS-K...