Advertisement
AssemBlY
PREPARATION
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts
are missing, please contact Customer Service before proceeding.
Place all parts on a soft, level surface for assembly. Estimated Assembly Time: 40 Minutes | DO NOT over-tighten
hardware.
1
Locate one A-Frame Top
(HINT: the Front Frame Legs are slightly longer than the Back
Frame Legs.) Place the A-Frame Top flat on the ground with the
90° angle to the left. Align the Front Frame Leg to the right side
of the A-Frame Top as shown. (Check orientation by
comparing the drilled holes to the inset drawing below right.)
Connect the pieces by fitting the Joint Bracket
(matching the holes in the Joint Bracket with the holes in the
two frame pieces where they meet). Insert 2 Female Screws
through the Joint Bracket and into the frame. Insert 2 Male
Screws
K
from the opposite side, as shown. Tighten each
Male Screw into the corresponding Female Screw using the
O
Hex Key
.
Hardware Used:
2
Finish assembling the first A-Frame by connecting the Back
C
Frame Leg
. Align the Back Frame Leg with the A-Frame Top
as shown. (Check orientation by comparing the drilled holes to
the inset drawing below right.)
Connect the pieces by fitting the Joint Bracket
(matching the holes in the Joint Bracket with the holes in the
two frame pieces where they meet). Insert 2 Screws
through the Joint Bracket and into the frame. Insert 2 Screws
from the opposite side, as shown. Tighten hardware using the
Hex Key
O
.
Hardware Used:
The left A-Frame is now complete. Assemble the right A-
Frame by following the same steps described above, but be
sure to place the Joint Brackets on the opposite side of the
joints (the Joint Brackets on each A-Frame should face
outwards, AWAY from the shelves supported by the A-
Frames.)
Hardware Used:
Contact us for assistance: (866) 985-7877 | www.balkenehome.com
A
and one Front Frame Leg
E
over the joint
K
Male Screw (6x10mm) x 2
L
Female Screw (8x15mm) x 2
E
K
Male Screw (6x10mm) x 2
L
Female Screw (8x15mm) x 2
K
Male Screw (6x10mm) x 4
L
Female Screw (7x48mm) x 4
B
.
L
over the joint
L
K
A
L
B
K
E
L
K
E
C
4
Advertisement
