Table of Contents
Advertisement
Note: You must remove the bezel assembly from the BladeCenter T unit
before you can access the blade server. Firmly grip the blue touch
points (at the top-left and top-right sides of the bezel) and
forcefully pull forward, lifting the bezel up and away from the
BladeCenter T unit. Carefully set the bezel assembly aside in a safe
place. (See the BladeCenter T Types 8720 and 8730 Installation and
User's Guide for detailed instructions about removing the bezel
assembly.)
Type 8720 or 8730
6. Pull the blade server out of the blade bay. Spring-loaded doors farther
back in the bay move into place to cover the bay temporarily.
7. Lay the blade server down on a flat, static-protective surface, with the
cover side up.
8. Place either a filler blade or another blade server in the bay within 1
minute for the BladeCenter unit and 20 minutes for the BladeCenter T
unit. The recessed spring-loaded doors will move out of the way as you
insert the blade server.
ES D
Bezel assembly
Chapter 2. Installing the I/O expansion card
11
Advertisement
Table of Contents
