Table of Contents
Advertisement
Available languages
Available languages
7
Troubleshooting
Drying process takes too much time
•
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
•
Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
•
Ventilation grids on the front side of the machine are blocked. >>> Remove the objects
(if any) that block ventilation in front of the ventilation grids.
•
Ventilation is not sufficient since the room where the machine is installed is very small.
>>> Open the door and window of the room to avoid the room temperature increase too
much.
•
Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.
•
Excessive laundry is loaded. >>> Do not load the dryer in excess.
•
Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your wash-
ing machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual dampness level.
•
It is likely that the selected programme did not suit the laundry type. >>>Checking the
care labels on clothes, select appropriate programme for the laundry type or use timer
programmes in addition.
•
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
•
Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
•
Excessive laundry is loaded. >>> Do not load the dryer in excess.
•
Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your wash-
ing machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is
set.
•
It is not plugged in. >>> Make sure that the machine is plugged in.
•
Loading door is ajar. >>> Make sure that the loading door is closed securely.
•
Programme is not selected or the Start / Pause / Cancel button is not pressed. >>> Make
sure that the programme has been set and it is not in "Pause" mode.
•
Childproof Lock is activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
•
Loading door is ajar. >>> Make sure that the loading door is closed securely.
•
There was a power failure. >>> Press Start / Pause / Cancel button to start the pro-
gramme.
•
Water tank is full. >>> Draining the Water Tank
Laundry has shrunk, become felted or deteriorated.
•
A programme suitable for the laundry type is not used. >>> Check the garment tag and
select a programme suitable for the fabric type.
Drum lighting does not turn on
•
Dryer is not switched on with the On / Off button. >>> Make sure that the dryer is
switched on.
•
Lamp is defective. >>> Call Authorized Service Agent to have the lamp replaced.
Water leaks from the loading door
•
Lint has accumulated on the inner surfaces of the loading door and on the surfaces of
the loading door gasket. >>> Clean the inner surfaces of the loading door and the sur -
faces of the loading door gasket.
EN / 54
(On models with lamp).
Dryer / User Manual
Advertisement
Table of Contents
