Table of Contents
Advertisement
Available languages
Available languages
5.10 Changing the delay time
If you want to change the time during the
countdown:
1.
Press Start/Pause/Cancel button.
Meanwhile the End Time symbol
illuminates and Start/Pause symbol
flashes.
2.
Press End Time ''+'' , ''-'' buttons to set
the new end time. End Time symbol and
Start/Pause symbol flash while making
the new settings.
3.
Press Start/Pause button to complete
setting the new end time. End Time
symbol and Start/Pause symbol flash.
C
When setting the end time again,
End Time symbol turns off and
Start/Pause symbol flashes
once the actual programme
duration appears on the display.
Programme starts immediately
without any delay if you press
Start/Pause/Cancel button.
5.11 Canceling the time delay
If you want to cancel the time delay count-
down and start the programme immediately:
1.
Press "Start/Pause/Cancel" button for 3
seconds to cancel the programme.
2.
Then, press "Start/Pause/Cancel" button
to select the desired programme.
5.12 Changing the programme
after it has started
You can use this feature to dry your clothes
under higher or lower temperatures after
your dryer has started.
For example;
1.
Press and hold the "Start/Pause/Cancel"
button for about 3 seconds to "Cancel"
the programme in order to select "Extra
Dry" programme instead of "Iron Dry"
programme.
2.
Select the programme with the
Programme Selection button.
3.
Press "Start/Pause/Cancel" button to
start the programme.
EN / 48
C
Child-proof lock of the machine
should not be active in order
to perform this operation. If
the child-proof lock is active,
deactivate it before performing
these operations.
5.13 Adding/removing laundry
in standby mode
In order to add or remove laundry after the
programme starts:
1.
Press the "Start/Pause/Cancel" button
to switch the dryer to "Pause" mode.
Drying process will stop.
2.
Open the door at "Pause" position and
close it again after adding or taking out
laundry.
3.
Press "Start/Pause/Cancel" button to
start the programme.
C
Any laundry added after the
drying process has started may
cause the dried clothes in the
machine intermingle with wet
clothes and the result will be wet
laundry after the drying process
is over.
C
Laundry may be added or taken
out as much as desired during
a drying process, but as this
process will interrupt drying
continuously, it will extend the
programme duration and increase
energy consumption. Therefore,
it is recommended to add laundry
before the drying programme has
started.
Dryer / User Manual
Advertisement
Table of Contents
