Table of Contents
Advertisement
Available languages
Available languages
Installation
3
Refer to the nearest Authorized Service
Agent for installation of the product. To
make the product ready for use, make sure
that the electricity and water drainage
system are appropriate before calling the
Authorized Service Agent. If they are not, call
a qualified technician and plumber to have
any necessary arrangements carried out.
C
Preparation of the product's
location as well as the electrical
and waste water installations is
under customer's responsibility.
B
Installation and electrical
connections of the product must
be carried out by the Authorized
Service Agent. Manufacturer shall
not be held liable for damages
that may arise from procedures
carried out by unauthorized
persons.
A
Prior to installation, visually check
if the product has any defects on
it. If so, do not have it installed.
Damaged products cause risks for
your safety.
A
Let your dryer wait for 12 hours
before starting to use it.
3.1 Appropriate installation
location
•
Install the product on a stable and level
surface.
•
Dryer is heavy. Do not move it by your-
self.
•
Operate your product in a well ventilated,
dust-free environment.
•
Do not block the air ducts in front of and
under the product with materials such as
long pile rugs, wooden blocks and bands.
•
Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
•
Once the product is installed, it should
stay at the same place where its connec-
tions have been made. When installing
the product, make sure that the rear
wall of it does not touch anywhere (tap,
socket, etc.). Also pay attention to select
an installation location which you will
not be required to change afterwards.
Dryer / User Manual
•
Place the product at least 1.5 cm away
from the edges of other furniture.
•
The rear surface of the tumble dryer
shall be placed against a wall.
B
Do not place the product on the
power cable.
3.2 Removing the
transportation safety
assembly
A
Remove the transportation
safety assembly before using the
product for the first time.
1.
Open the loading door.
2.
There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it
from its section marked with XX XX.
3.
Pull the nylon towards yourself and
remove the transportation safety
assembly.
A
Make sure that no part of the
transportation safety assembly
remains inside the drum.
3.3 Under counter installation
•
This product can be installed under a
counter if the height of the counter is
sufficient.
A
While using undercounter dryer, it
should never be operated without
undercounter installation part.
Dryer Depth
Stock number
of under-bench
2979700100
installation part
60 cm
54 cm
2973600100
EN / 39
Advertisement
Table of Contents
