Bobbin Winding; Bobbin Winding Through The Needle; Winding Specialty Threads - Husqvarna Viking Designer Sapphire 85 User Manual

Bobbin Winding

Bobbin Winding through the Needle

Make sure that the presser foot and the needle are in the up
position.
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only fits on one way, with
the logo facing up. Use only original HUSQVARNA®
VIKING® bobbins.
2. Thread the machine with the main spool pin in the
horizontal position.
Note: If the thread spool is too large to be in horizontal position, wind
the bobbin as described under "Winding Specialty Threads" below.
3. Bring the thread up from the needle, under the presser
foot and up to the right through thread guide (A).
Note: Use a metal presser foot when bobbin winding from the needle.
4. Guide the thread through the hole in the bobbin from
the inside to the outside.
Note: When using earlier version of HUSQVARNA®
VIKING® bobbins that do not have a hole, wind a few turns of
thread clockwise on the bobbin to get started.
5. Push the bobbin winding lever towards the bobbin to
wind. A pop-up message appears on screen. To adjust
winding speed drag the slider. Stop and start the bobbin
winding with the on-screen buttons. Hold the end of the
thread firmly when starting to wind. Once the bobbin
begins to wind, cut the excess thread.
Note: It is important that you cut the thread end close to the bobbin.
When the bobbin is full, the bobbin winder lever will move
back and the winding will stop automatically. The pop-up
message closes. Remove the bobbin and cut the thread using
the bobbin winding thread cutter.

Winding Specialty Threads

We do not recommend winding speciality threads such as
"invisible" or other stretchy threads, metallic or flat metallic
threads through the needle.
Always wind these threads at minimum speed.
1. Place an empty bobbin on the bobbin spindle at the front
of the machine. The bobbin only fits on one way, with
the logo facing up. Use only original HUSQVARNA®
VIKING® bobbins.
2. Place the large spool cap and a felt pad under the spool
on the main spool pin set in the vertical position.
3. Bring the thread over the Pre-Tension Thread guide (B)
and down around the thread tension disc (C), then
through thread guide (D) as illustrated.
4. See Bobbin Winding through the Needle, step 4-5.
B
C
2 Preparations
A
D
33