Toshiba MMD-AP0481HF2UL Service Manual page 44

How to change an indoor unit address by using a wired remote control
Use this method to change the address of indoor units (one to one or group control) that have had the original
address set automatically.
This procedure must be done while the units are not operating.
1
Simultaneously push and hold the "SET
than 4 seconds. If there are 2 or more units in a group, the first "UNIT No." indicated is the
header unit.
2
Push button (button of left side) repeatedly to select an indoor unit address to
UNIT LOUVER
change. If 2 or more units are controlled in a group the fan of the selected unit will be
energized.
3
Push the TEMP.
4
Push the TIME
section.
5
Push the "SET
6
Push " button (button of left side) repeatedly to select another indoor unit addresses
UNIT LOUVER
to change. Repeat steps 4 through 6 to continue changing indoor unit address and make
each of them unique.
7
Push button (button of left side) to review/confirm the revised addresses.
UNIT LOUVER
8
If the addresses have been changed correctly, push the "TEST
procedure.
/ buttons repeatedly to select
/ buttons repeatedly to change the value indicated in the SET DATA
" button, to save address.
00 00
SET DATA SETTING
3
TEMP.
5
TIMER SET
8
FILTER
RESET
Fin
1
", "CL ", and "TEST
13 13 13 13 13 for CODE No.
10
CODE No.
UNIT No. - 1
R.C. No.
ON / OFF
FAN MODE
TIME SAVE VENT
CL SWING/FIX
2, 6, 7
– 44 –
" buttons for more
" button to finish the
4