Toshiba MMD-AP0481HF2UL Service Manual page 76

1
2
3
4
5
6
16
8
Set temperature display
The selected set temperature is displayed.
9
Remote control sensor indicator
Displayed when the remote control sensor is used.
10
Pre-heat indicator
Displayed when the heating mode is energized or
defrost cycle is initiated.
While this indication is displayed, the indoor fan
stops or operate in fan mode.
11
No function indicator
Displayed when the function requested is not
available on that model.
12
Fan speed indicator
Fan speed is fixed and the indicator is fixed to
" High".
13
Central control indicator
Displayed when the air conditioner is controlled
centrally and used with central control devices
such as the central remote control.
If the use of the remote control is prohibited by the
central control, blinks when the ON/OFF,
MODE, or TEMP. button on the remote control is
pushed, and the buttons do not function. (Settings
that can be configured on the remote control differ
depending on the mode of the central control. For
details, read the Owner's Manual of the central
remote control.)
14
Operation mode controlled indicator
Displayed when MODE button is pushed while
operation mode is fixed to cool or heat by the air
conditioner administrator.
15
Operation ready display
This display appears on some models.
7-EN
13
7
8
14
9
15
10
12
11
16
Service display
Displayed while the protective device works or a
problem occurs.
Operation section
Once the settings have been configured, all you need to do is push the
TEMP.
12
2
FILTER
RESET TEST
5
3
1
button (Fan speed select button)
Only "High" is displayed.
2
button (Timer set button)
Use to setup the timer.
3
button (TEST button)
Use only for service.
(During normal operation, do not use this button.)
4
button
Use when a ventilator (commercially-available) is
connected. Push the button to turn ON/OFF the
ventilator. Turning ON/OFF the air-conditioner
also turns ON/OFF the ventilator.
* No ventilator is connected if " " appears on
the remote control display after pushing the
button.
5
button (Filter reset button)
Resets " FILTER" indication after cleaning.
6
button (Power save operation)
No function.
7
SWING/FIX
button
No function.
8
Operation lamp
Lights up during running.
Blinks when a problem occurs or the protective
device activates.
9
button
Turns on the unit when pushed, and turns off when
pushed again.
– 4 –
button from then on.
1 8
ON / OFF
9
TIMER SET FAN MODE
10
TIME SAVE VENT
4
SET CL SWING/FIX UNIT LOUVER
11
7 6
10
button (Operation mode select button)
Selects desired operation mode.
11
UNIT LOUVER
button (Unit / Louver select button)
UNIT button:
No function.
LOUVER button:
No function.
12
button
Adjusts the set temperature.
Select the desired set point by pushing
or TEMP.
OPTION:
Remote control sensor
Normally the temperature sensor of the indoor unit
senses the temperature. The temperature around the
remote control can also be sensed. For details, contact
your dealer.
TEMP.
EN
8-EN