Table of Contents
Advertisement
LINK Command
The link command allows you to set the operate device link rate that has been
connected on expander controllers. Typical parameters include: Max and Min
disk speed connected the SAS JBOD and High and Low external cable link
speed connected the SAS JBOD.
1. Set external cable link speed rate
Syntax
CLI>link c[0|1|2|3] High Low]
Index: c[0|1|2|3] External Cable Index
The cable c0, c1, or c2 is view from right to left or start from top to bottom.
High-Rate, Low-Rate: [11
PS. Pls. Save Config. & Reboot To Take Effect
CLI>st
Example:
CLI>link c0,c1 10 9 ;; set cable0 and cable1 link speed range [max=10(6G),
min=9(3G)]
CLI>st
CLI>
Reboot to take effect.
2. Set all slots with same link speed rate
Syntax
CLI>link [Index(D)| 255] High-Rate(D) Low-Rate(D)
Index: Slot Index
High-Rate, Low-Rate: [11
6.0G, and 11 means 12.0G
PS. Pls. Save Config. & Reboot To Take Effect
Appendix C. Command Line Interface
|10
|9
]
(12G)
(6G)
(3G)
|10
|9
]
(12G)
(6G)
(3G)
39
Advertisement
Table of Contents
