Table of Contents
Advertisement
Installation Guide
Slot07 Temp
09
Slot08 Temp
10
Slot09 Temp
11
Slot10 Temp
12
Slot11 Temp
13
Slot12 Temp
14
GROUP Command
The group command is used to associate the external port with the devices/phys
as one zone group. The three external cable ports and all devices/phys slots will
default associate with one zone group.
Syntax
gr {dev GroupNo[1..] {ci, cj, ck,..} Start-Index(D) End-Index(D)}
gr {off | [t10 off] }
dev : use drive slot index
GroupNo : groupno start from 1, max 8 groups ci, cj, ck,..:
external cable connector. i, j, k,.. is the index which range from 0 to 3. According
to view from connector side, index start from right to left or top to bottom. The
cable c0, c1, or c2 is view from right to left or start from top to bottom.
Start-Index : Start slot index of zone range, [1.. max drive]
End-Index : End slot index of zone range, [1.. max drive]
off : clear the zone group setting.
t10 off : turn T10 mode off.
Example:
CLI>gr
Current PHY Group Mode: T10
Group-1: C0, C1, C2, Slot: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16
Value: 0x0000000FFFFFFFFF
48
32
60
35
60
34
60
32
60
32
60
33
60
5
No
5
No
5
No
5
No
5
No
5
No
Advertisement
Table of Contents
