Pass Command; Lo Command - Sans Digital AccuSTOR AS424X12 Hardware Detailed User's Manual

Installation Guide
sasaddr
address

PASS Command

The pass command allows user to set or clear the SAS JBOD password
protection feature. Once the password has been set, the user can only monitor
and access the SAS JBOD setting by providing the correct password. The
password can accept max 8 chars and min. 4 chars. The manufacture default
password is "0000".
Syntax
CLI>pass [Enter]
Example:
CLI>pass
Old Password:****
New Password:****
Verify New Password:****
Password Changed But Not Save Permanently!
Note, use CLI command "st" to keep permanently.

LO Command

To exit the selected SAS JBOD CLI shell, use the lo command.
Syntax
CLI> lo [Enter]
Example:
CLI>lo
Password:
38
- Display expander SAS