Table of Contents
Advertisement
Loading 2.5" Hard Disk to the drive
bay. (for AccuSTOR 2.5" Series)
1. Put 2.5 HDD into the bay.
2. Fasten all 4 screws to mount HDD in the
bay and make sure the HDD is properly
tightened.
Place drive bays back into the system
1. Slide in drive bay; make sure the handle is
open fully.
2. Close the handle to engage the drive bay
into the slot.
Note
The hard drives in a JBOD should match in size and speed. All drives in any
array should be identical models with the same firmware versions.
Caution
Only use the screws offered with AccuSTOR RAID subsystem. Longer
screws might cause the drive damage.
All the drive bays (with or without hard drive) must be placed in the
AccuSTOR subsystem. AccuSTOR's cooling system is designed with full of
drive bays. Missing drive bays might cause the subsystem damage.
Chapter 2. Installation
15
Advertisement
Table of Contents
