Wantegrity HAWK-800 Series Constructions And Installations Instructions page 8

HAWK-800 Constructions and Installations Instructions –
Note: Mk2 connectors are installed in this picture (lower right). If you are installing the HAWK-800 into a Poly-800 MK2 this
picture helps to clarify the MK2 effects board connectors installation. The AtomaHawk connector is also shown (upper
right).
Step 4 – Install the Memory Chips
CAUTION
: For the following tasks, take extra care to ensure that you do not handle the memory chips by the
●
pins. Hold each chip by the plastic ends to avoid touching the pins.
Install the Boot ROM (which has a sticky label indicating the boot code version). Use the picture below to identify
●
its correct installation location (second from the left).
Install the 6264 static RAM chip in the far right position.
●
Install the two (2) 28C256 flash memory chips in the remaining middle positions.
●
Version 1.5c Board Discreet Component Location
https://www.hawk800.com
8 Of 29