HAWK-800 Constructions and Installations Instructions –
IMPORTANT: See page 7 for a picture showing the MK2 effects board connectors installed into board version 1.5c.
Step 18 - Install the Main Board back into the MK2 Synthesizer
Reinstall the MK2 main board (KLM-1032). Do NOT install the KLM-601 board at this time.
●
Reinstall all main board mounting screws and the ground shields etc.
●
Ensure that you reconnect all cables to the main board (obviously you can no longer connect CN13A and CN14A
●
cables to the main board because the plugs are now installed in the HAWK-800 board).
Step 19 - Install the KLM-601 and HAWK board into the MK2 Synthesizer
The KLM-601 board and HAWK board are installed in a specific "stacked" way. See the pictures below that show
●
the KLM-601 board mounted face down (the opposite to its original mounting method) and the HAWK board
mounted above it.
First, mount the KLM-601 board face down (trimmer pots down) and install only the top right hand screw. See the
●
picture below.
https://www.hawk800.com
15 Of 29