Wantegrity HAWK-800 Series Constructions And Installations Instructions page 14

HAWK-800 Constructions and Installations Instructions –
Step 16 – Reinstall the Effects board into the Poly-800 MK2 Synthesizer
Reinstall the effects boards back into the MK2 synthesizer.
●
Reinstall all board mounting screws and the ground shields etc.
●
Ensure that you reconnect all cables excluding cable CN15.
●
IMPORTANT: DO NOT RECONNECT THE CN15 CABLE TO THE EFFECTS BOARD. You may cut off (at the main board
●
mounting posts) the five wires that connect to connector CN15. CN15 is the five pin connector that has five wires
colored green, yellow, orange, red and brown. If you decide to leave the connector in place (not recommended)
then ensure that you properly secure the cable but DO NOT plug it into the CN15 plug on the effects board.
Step 17 – Install CN13A and CN14A Connectors in the HAWK-800 PCB
Now locate the CN13A and CN14A connectors that were removed from the main board and install them (with the
●
correct orientation) into the HAWK-800 board.
Use the picture below as a guide for the proper orientation of the connectors. When you are certain that you have
●
the orientation correct, solder them in place making sure that all pins are fully inserted and that the plastic
connectors are fully seated onto the board.
https://www.hawk800.com
14 Of 29