Special Section For The Ex-800 Synthe Module - Wantegrity HAWK-800 Series Constructions And Installations Instructions

HAWK-800 Constructions and Installations Instructions –
that you do not bend over any of the pins as you insert the plugs into the sockets. See the picture below.
Locate and install the 16 pin header cable assembly. Be careful to ensure that the pins are lined up correctly with
●
the sockets because it is very easy to incorrectly align the plugs in these sockets. Also take great care to ensure
that you do not bend over any of the pins as you insert the plugs into the sockets. See the picture below.
You should now move on to step 30.
●

Special Section for the EX-800 Synthe Module

NOTE: Steps 26 through to step 29 are for an EX-800 HAWK installation
only
Step 26 - Install the Main Board back into the EX-800 Synthesizer
Reinstall the original main board (KLM-596).
●
Reinstall all main board mounting screws and the ground shields etc.
●
Ensure that you reconnect all cables to the main board.
●
https://www.hawk800.com
21 Of 29