Wantegrity HAWK-800 Series Constructions And Installations Instructions page 17

HAWK-800 Constructions and Installations Instructions –
NOTE: The KLM-601 board is now safely located under the HAWK board. If any future adjustment is
needed to the trim pots on the KLM-601 board then the HAWK must be removed. Then the KLM-601
board must also be removed to allow trim pot adjustment. Then, when the adjustments are
completed the two boards must be replaced as discussed and shown above.
Step 20 – Install CN13, CN14 Cables
Install the CN13 and CN14 cables from the effects board to the HAWK-800 board. Connecting both ends of each
●
cable requires matching the plastic keys with the connectors.
Pay special attention to the orientation of the CN13 and CN14 cables. On the HAWK board, both CN13 pin 1 and
●
CN14 pin 1 are at top while on the effects board pin 1 is at bottom for both connectors.
https://www.hawk800.com
17 Of 29