Wantegrity HAWK-800 Series Constructions And Installations Instructions page 22

HAWK-800 Constructions and Installations Instructions –
Step 27 - Install the KLM-601 board into the EX-800 Synthesizer
Reinstall the KLM-601 board by using the upper left hand screw only. See the picture below.
●
Step 28 - Mounting the HAWK board in an EX800.
Mount the HAWK board into the EX-800. Use the picture above as a guide.
The HAWK board is mounted on top of the KLM-601 board in a "stacked" method.
●
Locate the nylon spacer and nylon washer supplied with the HAWK kit.
●
Locate the 3mm metric screw supplied with the HAWK kit.
●
Mount the HAWK board using the below right hand screw mounting point that will secure both the KLM-601 and
●
the HAWK board.
Ensure that the HAWK board is mounted so that it allows the proper insertion of the 16 pin header into the IC29
●
socket. See the picture below.
https://www.hawk800.com
22 Of 29