Replacing The Bulb - Whirlpool Slide-Out Range Hood Installation And Use Manual

6. Place charcoal filter into opening, resting the back of the filter
on tabs "A," then clip filter tabs "C" into slots "B."
B
A. Tab
B. Slot
C. Filter tabs
7. Repeat to install other charcoal filter.
8. Replace metal grease filters. See "Metal Grease Filters"
section.
To Replace Charcoal Filters
1. Turn fan and lights off.
2. Pull out on the range hood screen to expose the filters.
3. Remove the 2 metal grease filters. See "To Remove Metal
Grease Filters" section.
4. Set metal grease filters aside.
5. Remove and discard both charcoal filters.
6. Install replacement charcoal filters by placing charcoal filter
into opening, resting the back of the filter on tabs "A," then
clip filter tabs "C" into slots "B."
7. Replace metal grease filters. See "Metal Grease Filters"
section.
14
C
A

Replacing the Bulb

Turn off the range hood and allow the bulb to cool.
Use a 15-watt fluorescent bulb with 30" (76.2 cm) unit and 18-
watt bulb with 36" (91.4 cm) unit.
1. Disconnect power.
2. Remove the screws above the light cover and set them aside.
3. Pull the light cover forward slightly and then downward to
remove the cover.
4. Replace the light bulb.
5. Lift cover back into position.
6. Replace the screws.
KWVU Model Series
A. Screws
GZ & IH Model Series
A. Screws
A
A